Crossfire Pro / Crossfire Water Dable Dimple Die

Quick dimple die that you can make by stacking rings together. This dimple die allows the drain plug to sit flush with the bottom of the table.

I used 3/16" steel but other thicknesses and stacking combinations could work. I just superglued the stack together, but if I were to do it again I would tack weld the rings together. On the second dimple, the alignment ring came apart making my dimple off-center to the drain hole.

The bolt going through the center is 5/8".

The fit is a bit loose in the table and on the bolt, but I think it's okay.

The brass fitting is difficult to get tight because it will spin when you try to tighten it. To get around this I cut a slot in the brass fitting so I could somewhat hold it with a brake drum tool. I also installed the drain plug into the brass fitting outside of the machine using a vice. This stops the part where when you tighten the plug the fitting gets loose.